Payment & Shipping Terms:
rapid diagnostic test kits,
One Step Rapid Test
A rapid test for the simultaneous, qualitative detection of multiple drugs and drug metabolites CE certified
The Multi-Drug Rapid Test Cassette for AMP /MET /COC /OPI /THC /PCP /MTD /MDMA /OXY /COT /K2 /BZO is a lateral flow chromatographic immunoassay for the qualitative detection of multiple drugs and drug metabolites in saliva at the following cut-off concentrations:
This assay provides only a preliminary analytical test result. A more specific alternate chemical method must be used in order to obtain a confirmed analytical result. Gas chromatography/mass spectrometry (GC/MS) and gas chromatography/tandem mass spectrometry (GC/MS/MS) are the preferred confirmatory methods. Professional judgment should be applied to any drug of abuse test result, particularly when preliminary positive results are indicated.
The Multi-Drug Rapid Test Cassette for AMP /MET /COC /OPI /THC /PCP /MTD /MDMA /OXY /COT /K2 /BZO and their metabolites is a rapid, saliva screening test that can be performed without the use of an instrument. The test utilizes monoclonal antibodies to selectively detect elevated levels of specific drugs in human saliva
How to use?
Allow the test cassette, specimen, and/or controls to reach room temperature (15-30°C) prior to testing. Instruct the donor to not place anything in the mouth including food, drink, gum or tobacco products for at least 10 minutes prior to collection.
INTERPRETATION OF RESULTS
(Please refer to the illustration above)
NEGATIVE:* Two lines appear. One colored line should be in the control region (C), and another apparent colored line adjacent should be in the test region (Drug/T). This negative result indicates that the drug concentration is below the detectable level.
*NOTE: The shade of color in the test line region (Drug/T) will vary, but it should be considered negative whenever there is even a faint line.
POSITIVE: One colored line appears in the control region (C). No line appears in the test region (Drug/T). This positive result indicates that the drug concentration is above the detectable level.
INVALID: Control line fails to appear. Insufficient specimen volume or incorrect procedural techniques are the most likely reasons for control line failure. Review the procedure and repeat the test using a new test panel. If the problem persists, discontinue using the lot immediately and contact the manufacturer.
A procedural control is included in the test. A colored line appearing in the control region (C) is considered an internal procedural control. It confirms sufficient specimen volume, adequate membrane wicking and correct procedural technique.
Contact Person: selina